How to Make a Book Bin
Supplies Needed
¾"x4’x8’ Medium Density Fiberboard (MDF) Table saw or portable circular saw and straightedge Four clamps with at least 16" of jaw capacity Wood glue (optional) Cordless drill/driver Countersink drill bit #8x1½" flathead screws (46) Wood putty Spackling knife Sandpaper or sanding block Tack cloth Paint Paintbrush or paint roller Wallpaper (optional), we used Dalmation Spot from Livettes Wallpaper Four legs Four leg mounting plates
Step 1: Cut Wood
Cut all the wood pieces using a table saw or a portable circular saw and straightedge. A table saw works best, ensuring square pieces of uniform width and length. You’ll need:
One ¾"x16"x36" MDF for the bottomTwo ¾"x9"x36" MDF for the front and backFour ¾"x9"x14½" MDF for the ends and dividers
Use extra care when using portable tools to ensure precise cuts. MDF is a man-made material, widely available at home centers, that will not warp or crack over time. It also sands easily and takes paint well. But you could, instead, use pine for lighter-weight assembly.
Step 2: Clamp the Boards into Position
Lay the bottom board (¾"x16"x36") on a flat work surface. Stand the front, back, ends, and dividers on top of the base in their final positions. Place clamps across the width of the assembly at each end and at the dividers to hold the pieces in place. With the clamps in position, but not fully tightened, tap the ends and dividers until they are spaced 11" apart, square to the front and back, and all adjoining edges are flush. If desired, you can add wood glue to the joints before tightening the clamps so the pieces can’t move.
Step 3: Screw Together
Where each piece meets another, draw a line showing where the screws should go, so that they center on the edge of the adjoining piece. With a countersink drill bit, drill three equally spaced holes, each with a counterbore just deep enough to hold whatever material will hide the screw head. Drive the screws through the front and back and into the ends and dividers. Do not attach the bottom board. Be careful not to overdrive the screws; doing so could make MDF bulge.
Step 4: Attach Base
Remove the clamps. Flip the assembly over and position the bottom. Screw on the bottom.
Step 5: Fill the Holes and Paint
Fill the screw holes with wood putty. Let them dry, then sand any rough surfaces and sharp edges. Wipe away sawdust with a tack cloth. Apply two coats paint to the bin and legs, then let dry completely.
Step 6: Line with Wallpaper (Optional)
If you like, line the dividers with temporary wallpaper or adhesive shelf liner. You can order the pieces precut from the source listed above or cut them to size yourself. Make sure you purchase enough to cover all inside surfaces.
Step 7: Attach Legs
Screw on a leg mounting plate near each corner of the bottom, about 1" from edges. Thread a leg into each mounting plate.
